STILLO PURE WATER DISTILLER - £295.00

Using water produced by Stillo means to be careful about the kind of water you are putting inside your sterilizer. Stillo assures one of the essential features for an optimal working of your sterilizer, completely avoiding any problem caused by using a non pure water.

STILLO

Easy to use and runs very quietly.

The conductivity value of the water obtained is ideal for use in the steriliser. Produces up to 4 litres of demineralised water in 6 hours, entirely adequate for continuous use of Mocom sterilisers. Switches off automatically at the end of the process.

IMPORTANT

It is essential to remove the limestone residues after each cycle, and perform thorough cleaning after several operating cycles to ensure the Stillo distiller continues to operate efficiently and the quality of the water remains constant over time.

In addition, it is necessary to periodically replace the active carbon filter positioned at the condenser output.

  • TECHNICAL DATA SHEET
  • Measurements DxH: 20x36 cm
  • Weight: 3.5 Kg
  • Capacity: 4 litres
  • Power consumption: 580W (total) Heater 565W
  • Cooling fan: 15W
  • Power supply:
  • AC 120V/60Hz
  • AC 220V/50-60Hz
  • AC 230V/50Hz
  • AC 240V/50Hz
  • STANDARD KIT
  • 1 power cable
  • 1 protective cover
  • 1 distilled water tank
  • 1 detergent solution
  • 6 active carbon filters

Part of the Hand-Held X-Ray Range